Radiator Cleaner by LIQUI MOLY – LM Performance

4.8

(563)

Write Review

$ 4.50

Add to Cart

Qty

In stock

Description

PRODUCT DESCRIPTION Deposits in the cooling/heating system create blockages for heat exchange and they also block thermostat valves and control mechanisms. When engine temperatures are too high, the engine runs uneconomically and suffers excessive wear at considerable risk of damage. LIQUI MOLY Radiator Cleaner removes
PRODUCT DESCRIPTION Deposits in the cooling/heating system create blockages for heat exchange and they also block thermostat valves and control mechanisms. When engine temperatures are too high, the engine runs uneconomically and suffers excessive wear at considerable risk of damage. LIQUI MOLY Radiator Cleaner removes deposits containing oil and lime, and ensures that the engine runs reliably and at the optimum temperature. Does not contain aggressive acids or alkalis. For all coolant and heating systems in water-cooled engines. 300 ml is sufficient for 10 l of coolant (dosage 1:33). Compatible with all conventional coolant additives and antifreezes. PRODUCT DETAIL A concentrate specially developed for cooling systems in general but particularly those in motor vehicles. Dissolves contaminants containing oil and lime in radiators, heating systems, lines and engines. Modern formula containing complexants with active cleaning agents. PROPERTIES - Does not contain acids or alkalis- Disperses sludge- Removes oil and grease residues- Chemical conversion of lime- Neutralizes acids- Neutral behavior in contact with rubber and plastics- Compatible with antifreezesTECHNICAL DATA Form: flüssig / liquidColor / appearance: weiß, leicht trüb / white, light unclearHazard class as per German VbF: keine / nonepH value: ~8,7Solubility in water: löslich / solubleOdor: charakteristisch / characteristicDensity at 20 °C: 1,015 g/cm³AREAS OF APPLICATION Suitable for all cooling water systems in motor vehicles, buses and commercial vehicles. APPLICATION Add contents to the cooling water. Then start up the heater and, depending on the level of contamination, let the engine run at operating temperature for 10 – 30 min. After finishing cleaning, drain the coolant/cleaner mixture, thoroughly flush the cooling system with water and refill it according to the manufacturer’s instructions. The content (300 ml) is sufficient for 10 l of coolant (dosage 1:33).