That adjustment should be set once and left alone. Use lightburn to control the lps via the controller. If you change that adjustment it will throw off all of your known power settings. This might helpβ¦ Good luck πΈ
Laser Smoothies At Maker Faire
MKS DLC32 vs M2 - #18 by DougL - GRBL - LightBurn Software Forum
K40 Laser not Responding with laserburn - Board Configuration and
Omtech K40+ and Omtech 50w power differences? - Community Laser
K40 homing in wrong spot - LightBurn Software Questions
Laser head wont move - Board Configuration and Setup - Cohesion3D
Full Spectrum MLE-40 - Smoothieware - LightBurn Software Forum
Help needed. K40 Board swap to smoothieware - Lasers - Maker Forums
Laser head wont move - Board Configuration and Setup - Cohesion3D
Why no K40 w/ Lightburn - Community Laser Talk - LightBurn
New OMTech 80W Laser, Cant Connect to Lightburn - LightBurn
K40 Not firing in auto - Smoothieware - LightBurn Software Forum
Lightburn Says connected, but will not move laser head or run