The Bulldog Original Bender - Rack-A-Tiers Since 1995

The Bulldog Bender is designed and manufactured by an electrician for electricians. Used for bending wires in panels, disconnects, LB's and wire-ways.

Specialty Electrical Tools

Bulldog Bender used for bending wire in panels, disconnects, LBs & wireways. Bend up to 500MCM. Replacement smooth dowels for the Bulldog Bender part numbers: Part #78500, Part #78501, Part #78502. Dimensions: 1-in x 1-in x 1-in.

Rmi 78050 Bender Hourglass Dowel

RACK-A-TIERS 78500 The Bulldog Original Cable Bender 500 kcmil Conduit

The Bender’s friend is an easy to use template for bending perfect 90’s in your PVC. To be paired with a heat source, the Bender’s Friend will allow

Bender's Friend

Bender's Friend - Rack-A-Tiers Since 1995

2 Minute Tools - Distributor Series

Factory Power Monitoring/Metering - Rack-A-Tiers Since 1995

RACK-A-TIERS 78500 The Bulldog Original Cable Bender 500 kcmil Conduit

The Bulldog Original Bender - Rack-A-Tiers Since 1995

Slim handle allows for easy access into tight spaces Each end is offset 90 degrees for maximum bending Adapter allows for bending in places other

Bulldog Bender 3 Piece Set 500 MCM and smaller Cable Bender

Hoppy Bender - Rack-A-Tiers Since 1995

Slim handle allows for easy access into tight spaces Each end is offset 90 degrees for maximum bending Adapter allows for bending in places other tools can't reach Powder coated handle for durablilty Capacity: 500 MCM and smaller - 18 handle length Bending large gauge electrical cables is difficult - especially in tight spaces.

Bulldog Bender 3 Piece Set 500 Mcm and Smaller Cable Bender