I made this today, and must share with you all. I mounted a Dremel 290-01 120-Volt Engraver to a Nomad 883. The results were amazing. The spindle of the Nomad is 1.250” diameter. I can connect to it with 1.25” split shaft collar. The Dremel has a convoluted ergonomic handle for the human hand. I was able to slide a 1” long piece of 1.25” thin wall aluminum tubing over the tip of the engraver and up till it stopped sliding. Covered that end with hot melt glue. Held it in a vise upright in a
First Aluminum project on Nomad 3 -- Business Card Holder - Gallery - Carbide 3D Community Site
Dremel attachment to nomad 883 - Nomad - Carbide 3D Community Site
SOLD: Nomad 3 with Extras - CA - Nomad - Carbide 3D Community Site
Nomad - Custom linear rail Z conversion with new 500watt spindle - Unsupported - Carbide 3D Community Site
Dremel attachment to nomad 883 - Nomad - Carbide 3D Community Site
Nomad 883 Pro Dust Head - #28 by mbellon - How To - Carbide 3D Community Site
Nomad modified with dust collector - Carbide 3D Community Site
1/4-in X 2-ft X 4-ft Maple Sanded Plywood In The Plywood, 41% OFF
1/4-in X 2-ft X 4-ft Maple Sanded Plywood In The Plywood, 41% OFF
3D Model of the Nomad 883 Pro - Nomad - Carbide 3D Community Site
1/4-in X 2-ft X 4-ft Maple Sanded Plywood In The Plywood, 41% OFF
Dremel attachment to nomad 883 - Nomad - Carbide 3D Community Site
Nomad 883 Pro, my first CNC mill
Dremel attachment to nomad 883 - Nomad - Carbide 3D Community Site