Freeze Display at horizontal position - Project Guidance - Arduino Forum

hi everyone. I am working on a project where I need to freeze/pause the displayomn the OLED if the arm of the platform is horizontal. Due to space constraints I can not use an acceleromete hence am using a tilt switch SW 520D. The sensor needs to be small and just give a high or low value at 180 degrees only. I am using an arduino nano as the microcontroler on the platform say at a distance of 4-5 inches.The tilt switch is mounted at the tip of the rod ( please refer to the attached diagram) . R

Stepper Motors, Limit Switches and buttons - Project Guidance - Arduino Forum

Arduino and I2C LCD freezing. - Displays - Arduino Forum

Arduino freezes and lcd get blank on load switching - #22 by Paul_B - Project Guidance - Arduino Forum

16x2 LCD (parallel) either freezing or printing gibberish - Displays - Arduino Forum

Qwiic Micro OLED Hookup Guide - SparkFun Learn

Arduino Nano Atmega328p freezes and starts lagging and reset-ing after a few seconds running on battery--- it doesn't freeze or resets when ran onUSB - Home Automation - Arduino Forum

ESP32 freezes when 3.3V relay module turns off - General Electronics - Arduino Forum

Arduino freezes in real world test - Project Guidance - Arduino Forum

Millis Code still freezing the LCD display - Project Guidance - Arduino Forum

Arduino and I2C LCD freezing. - Displays - Arduino Forum

I'm a noob when it comes to anything involving electricity. Thus, /r/arduino, I need your help. If you do, I'll credit you and send your name to space. : r/arduino